Filter
Top Products
5
1. With the help of a second person, carefully raise the
treadmill to the upright position. While a second person
tips the treadmill to one side and holds it, insert one of
the Extension Legs (103) into the treadmill as shown.
Make sure that the Extension Leg is turned so the Base
Pad (97) is on the bottom.
Next, tip the treadmill to the other side and insert the
other Extension Leg (not shown) in the same way. Lower
the side of the treadmill so that both Extension Legs
(103) are resting flat on the floor.
103
97
1
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions in step 2 to lower the
treadmill.
Attach the latch support to the center hole in the left Upright
(82) with a 3/4Ó Screw (89). Make sure that the Screw is
tight, but do not overtighten it; if the Screw is over-
tightened, the latch will not slide smoothly.
Remove the tape from the Latch Assembly (77). Be care-
ful to hold the parts in place. Inset drawing (a) shows
how the Latch Assembly fits together. Refer to inset
drawing (b). Insert the springs into the bracket as shown.
Make sure the tabs are touching the bracket and the back
end of the latch is flush with the bracket.
Attach the Latch Assembly (77) to the left Upright (82)
with two 3/4Ó Screws (89).
77
89
89
82
2
Flush
Bracket
a
b
Latch
Support
Latch
Spring
Spring
Tabs