Filter
Top Products
IO/20 EXERC|SE B|KE MAINTENANCE
[] Moving your 10/20 bike
Carefully lift the horizoetal rear floor support to move and steer
the 20 biketo another location (Fig. A). Pullthe handlebars
towards you, leaning the bike down, to move and steer the 10
bike to another location (Fig. B). Be gentle while moving the unit
as any sharp impact directly or indirectly to the computer can
affect computer operation.
[] DaiJy maintenance
Usea damp cloth to wipe your bike and computer free of sweat.
_ IMPORTAN_ To avoid damaging the finish on your bike and
computer, never usea petroleum-based solvent when cleaning.
Avoid getting excessive moisture on the computer.
! RepJacing the batteries
If the console does not power up, replacethe batteries in
the back of the console with fresh Gcel[ batteries. Insert the
batteries as indicated in the battery bay.
NOTE: Ifyou prefer, you may power the bike with aClass 2
Transformer AC Adapter.The adapter plugs into the DC Connector
Jack on the back of the console.
The adapter must be purchased separately and can be obtained
from many electronic stores.
AC ADAPTER
JCLASS2TRANSFORMER
I'_ HNPUT: 120MAC 60Hz 5.7V
[_;_ I OUTPUT: 6VDC 500mA
The AC adapter specifications are:
,, INPU]! AC 120v60Hz 5.7W
,, OUTPLFRDC6V 500mA
,, DC PLUG:
Outer Diameter 5.5 ± 0.1
InternalDiameter 2.1 ± 0.1
Length 10± 0.1
DCWire Length 71 in. (180cm)
Wire Diameter 24AWG
The DC Connector Jack configuration:
,, Outside: Negative
,, Inside: Positive
15