Filter
Top Products
13
The right display—This display will show the dis-
tance that you have walked or run, the number of
1
/4-mile laps you have completed, the speed of
the walking belt, and the approximate numbers of
c
alories
a
nd
f
at calories
y
ou have burned (see
FAT BURNING on page 25).
The right display will also show your heart rate
when you use the handgrip pulse sensor. In addi-
tion, during heart rate programs the right display
will show a heart rate bar that shows your heart
rate as a percentage of your estimated maximum
heart rate (see step 3 on page 18 for an explana-
tion of your estimated maximum heart rate). For
example, if four to six segments of the bar appear,
your heart rate is between 60% and 70% of your
estimated maximum heart rate.
Note: The console can display speed and dis-
tance in either miles or kilome
ters. The letters
“MPH” or “Km/H” will appear in the right display to
show which unit of measurement is selected. To
change the unit of measurement, see HOW TO
USE THE INFORMATION MODE on page 20.
For
simplicity, all instructions in this section refer
to miles.
To reset the displays, press the Stop button, re
-
move the key, and then reinsert the key.
Measure your heart rate if desired.
Before using
the handgrip
pulse sensor,
remove the
sheets of clear
plastic from the
metal contacts.
In addition,
make sure that your hands are clean. Next, hold
the handgrip pulse sensor with your palms resting
o
n the metal contacts;
a
void moving your hands
.
When your pulse is detected, the heart-shaped in-
d
icator in the right display will flash each time your
heart beats, one or two dashes (– –) will appear,
and then your heart rate will be shown.
For the
most accurate heart rate reading, continue to
hold the contacts for about 15 seconds.
Note: The handgrip pulse sensor is intended to be
used only for heart rate measurement.
Do not
use the handgrip pulse sensor as a handlebar.
Always hold the handrails for support when
you are not measuring your heart rate.
Turn on the fan if desired.
To turn on the fan, press the button below the fan.
To turn on the fan at high speed, press the button
a second time. To turn off the fan, press the but-
ton a third time. Note: If the fan is on when the
walking belt is stopped, the fan will automatically
turn off after a few minutes.
When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest setting
when the treadmill is folded to the storage posi-
tion or the treadmill will become damaged. Next,
remove the key from the console and put it in a se-
cure place. Note: If the displays remain lit after
the key is removed, the console is in the
“demo” mode. See HOW TO USE THE INFOR-
MATION MODE on page 20 and turn off the
demo mode.
When you are finished using the treadmill
,
switch the reset/off circuit breaker to the “off”
position and unplug the power cord.
8
7
6
Heart Rate Bar
Contacts