Filter
Top Products
12
HOW TO USE PRESET WORKOUT PROGRAMS
Insert the key fully into the console.
See HOW TO TURN ON THE POWER on page
10.
Select one of the preset workout programs.
When the key is inser-
ted, the manual mode
will be selected. To se-
lect a preset workout
program, press the
Program Select button
repeatedly until one of
the Walk or Jog indicators lights.
When a preset workout program is selected, the
Distance/Incline/Laps display will flash the maxi
-
mum incline setting of the program, and the
Speed display will flash the maximum speed set-
ting, for six seconds. The Time/Segment Time/
Pace display will show how long the program will
last.
The LED matrix will
show the first five
speed settings of the
program. The profiles
on the right side of the
LED matrix show how
the speed and incline
of the treadmill will change during the programs.
Press the Start button or the Speed
▲
▲
button to
start
the program.
A moment after the button is pressed, the tread-
mill will automatically adjust to the first speed and
incline settings of the program. Hold the handrails
and begin walking.
Each program is divided into several time seg-
ments of different lengths. (The Time/Segment
Time/Pace display will show both the time remai-
ning in the program and the time remaining in the
current segment of the program.) One speed set
-
ting and one incline setting are programmed for
each segment. (The same speed and/or incline
setting may be programmed for consecutive seg
-
ments.)
The speed setting for
the first segment is
shown in the flashing
Current Segment co-
lumn of the LED matrix.
(The incline settings are
not shown in the matrix.)
The speed settings for
the next five segments
are shown in the columns to the right.
When only three seconds remain in the first seg-
ment of the program, both the Current Segment
column and the column to the right will flash and a
series of tones will sound. In addition, if the speed
and/or incline of the treadmill is about to change,
the Speed display and/or the Distance/Incline/
Laps display will flash to alert you. When the first
segment is completed, all speed settings will move
one column to the left. The speed setting for the
second segment will then be shown in the flashing
Current Segment column and the treadmill will au-
tomatically adjust to the speed and incline settings
for the second segment. Note: If all of the indica-
tors in the Current Segment column are lit after the
speed settings have moved to the left, the speed
settings will move downward so that only the hig-
hest indicators appear in the LED matrix. If some
of the indicators in the Current Segment column
are not lit when the speed settings move to the left
again, the speed settings will move back up.
The program will continue in this way until the
speed setting for the last segment is shown in the
Current Segment column and no time remains in
the program. The walking belt will then stop.
If the speed or incline setting is too high or too low
during the program, you can manually override
the setting by pressing the Speed or Incline but
-
tons. Every few times a Speed button is pressed,
an additional indicator will light or darken in the
Current Segment
column. (If any of the columns
to the right of the Current Segment column have
the same number of lit indicators as the Current
Segment column, an additional indicator may light
or darken in those columns as well.)
Note: If you
manually override the speed or incline setting,
when the next segment begins, the treadmill
will automatically adjust to the speed and in
-
cline settings for the next segment.
3
2
1
Current Segment