Filter
Top Products
8
2b
B
81
PULSE
Jack
1. Make sure that the power cord is unplugged. Remove
the indicated Screws (87) from the back of the Console
Base (88).
2. Connect the Short Jumper Wire (A) to the wire on the
Receiver (B). Connect the other end of the Jumper Wire
to the PULSE jack on the back of the Console (see draw-
ing 2b). Next, peel the paper off the pad on the bottom of
the Receiver (B). Turn the Receiver so the cylinder is
on the side shown, and press the Receiver into the bot-
tom of the Console Base (81) in the location indicated by
the dotted line. Note: The included Long Jumper Wire is
not needed and can be discarded.
Make sure that no wires are pinched. Reattach the
back of the Console Base (88) with the Screws (87) (see
step 1 above).
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the receiver
included with the chest pulse sensor.
88
87
1
A
2a
Cylinder