Filter
Top Products
11
11. Firmly tighten the four 5/16" x 1" Flat Head
Patch Bolts (3) and the two 5/16" x 1" Patch
Bolts (4) (only one side is shown).
With the help of a second person, hold the con-
sole assembly near the Right Handrail (83) and
the Left Handrail (not shown).
Connect the Upright Wire (87) to the console
wire. See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN YOU TURN ON THE
POWER. Remove the wire tie from the Upright
Wire.
Connect the Console Ground Wire (109) to the
ground wire from the console assembly.
Console
Assembly
11
Console
Wire
Wire
Tie
Ground Wire
83
87
4
3
109
87
Console
Wire
10. Attach the Crossbar (107) to the Handrails (82,
83) with four #10 x 3/4" Screws (2) and four #10
Star Washers (12). Do not tighten the Screws
yet.
Insert the Console Frame (102) into the
Handrails (82, 83). Attach the Console Frame
with four 1/4" x 1" Patch Bolts (9). Be careful
n
ot to pinch the Upright Wire (87). Do not
tighten the Patch Bolts yet.
Firmly tighten the four #10 x 3/4" Screws (2)
and then the four 1/4" x 1" Patch Bolts (9).
10
107
12
9
2
83
1
02
8
2
87
9
12
2