Reebok Fitness RBEX69740 Home Gym User Manual


 
7
12. Firmly tighten the four M8 x 31mm Button Screws
(69) in the Seat Carriage (11). Note: There are two
Button Screws in each side.
Pull the seat knob and slide the Seat Carriage (11)
to the desired position. Release the seat knob and
slide the Seat Carriage back and forth slightly
until it locks into position. Make sure to regularly
tighten the four M8 x 31mm Button Screws (69).
13. Identify the Right Pedal (37), which is marked with
an “R.” Using an adjustable wrench, firmly tighten
the Right Pedal
clockwise
into the Pulley/Crank (19).
Tighten the Left Pedal (not shown)
counterclockwise
into the Pulley/Crank on the left side. After using
the exercise cycle for one week, retighten the
Pedals.
Attach the Right Pedal Strap (38) to the Right Pedal
(37), and press the end of the Right Pedal Strap
onto the tab on the Right Pedal.
Attach the Left
Pedal Strap (not shown) in the same way.
11
69
19
38
37
Tab
12
13
14. Make sure that all parts are properly tightened before you use the exercise cycle. Place a mat
beneath the exercise cycle to protect the floor
.
11. Pull the seat knob and slide the Seat Carriage (11)
onto the Seat Rail (7).
See the inset drawing. Hold the Bumper Axle (50)
inside of the Seat Rail (7). Attach the two Bumpers
(47) to the ends of the Bumper Axle with two M6 x
16mm Screws (70) and two M6 Washers (25) as
shown. Press the Seat Rail Endcap (23) into the
end of the Seat Rail.
11
Knob
7
11
23
50
70
47
25
25
7
10. Attach the Backrest (13) to the Seat Carriage (11)
with four M6 x 38mm Hex Screws (68) and four M6
W
ashers (25).
1
3
25
1
1
25
68
1
0
47
70
Knob