Filter
Top Products
5
2. Attach the Rear Stabilizer (3) to the rear of the
Frame (1) with two M10 x 105mm Carriage Bolts
(
74) and two M10 Nylon Locknuts (63).
3. While a second person holds the Handlebar Post (6)
near the Frame (1) as shown, connect the Upper
Wire Harness (16) to the Lower Wire Harness (58).
Carefully slide the Handlebar Post (6) onto the
Frame (1);
be careful to avoid pinching the W
ire
Harnesses (16, 58). Attach the Handlebar Post to
the Frame with four M8 x 25mm Button Screws (27)
and four M8 Split Washers (65).
2
3
3
6
27
27
65
65
1
16
58
65
65
5.
Insert the Bookrack (55) into the slots in the Console
(9). Attach the Bookrack to the Console with two M4
x 25mm Screws (66). Be careful not to pinch the
wires in the Console.
5
55
66
9
63
6
3
74
1
4. The Console (9) requires four “D” batteries (not
included); alkaline batteries are recommended.
Press the indicated tab on the battery cover and
remove the cover. Press four batteries into the bat-
tery clips; make sure that the batteries are orient-
ed as shown by the markings inside of the bat-
tery clips. Then, reattach the battery cover.
9
Battery
Cover
Batteries
4