Filter
Top Products
6
ASSEMBLY
Assembly requires two persons. Place all parts of the elliptical crosstrainer in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included allen wrench and push nut tool , and your own phillips
screwdriver rubber mallet and two adjustable wrenches .
2. Hold the Upright (6) in the position shown. Carefully
pull the Resistance Control Wire (48) and the Reed
Switch Wire (52) up through the Upright until there is
no slack between the Upright and the Frame (1).
Slide the Upright (6) onto the Frame (1). Be careful
to avoid pinching the Resistance Control Wire
(48) and the Reed Switch Wire (52). Tighten a 3/8Ó
Button Head Screw (65) and a 3/8Ó Lock Washer
(66) into the front of the Upright and the Frame.
Next, tighten two 3/8Ó Button Head Screws and 3/8Ó
Lock Washers into the sides of the Upright and the
Frame. Note: It may be necessary to loosen the front
Button Head Screw slightly in order to attach the
other two Button Head Screws. Firmly tighten all
three Button Head Screws.
1. Attach a Wheel Bracket (82) to the front of the Frame
(1) with a 3/8Ó Button Head Screw (65) and a 3/8Ó
Flange Nut (88). Attach a Wheel (83) to the Wheel
Bracket with a 3/8Ó x 1 3/4Ó Bolt (84) and a 3/8Ó
Nylon Locknut (85). Make sure that the Wheel turns
after you have tightened these parts. Attach the other
Wheel Bracket and Wheel to the Frame in the same
way.
Press two 2Ó x 3Ó Caps (38) onto the front of the
Frame (1). Press the other two 2Ó x 3Ó Caps onto the
back of the Frame (not shown).
2
6
48
52
65
65
65
66
66
1
3. The Console (43) requires two ÒAAÓ batteries (not
included). Alkaline batteries are recommended.
To install batteries, turn over the Console (43) (see
the inset drawing). Insert two batteries into the bat-
tery clip. Make sure that the negative ends of the
batteries (marked ÒÐÓ) are touching the springs
in the battery clip.
3
43
43
Batteries
Battery Clip
1
88
38
84
82
85
83 65
1