Filter
Top Products
6
4. Attach the Handlebar (7) to the Handlebar Post (6)
with three M8 x 25mm Button Screws (19) and
three M8 Split Washers (28). Make sure to feed
the Upper Wire Harness (16) and the Pulse
Sensor Wires (71) through the indicated hole in
the Handlebar.
5. While another person holds the Console (9) near
the Handlebar (7), connect the Pulse Sensor Wires
(71) to the console wires. Next, plug the Upper Wire
Harness (16) into the socket in the back of the
Console.
Insert all excess wiring down into the Handlebar
Post (6). Attach the Console (9) to the Handlebar
(7) with four M4 x 16mm Screws (21). Be careful to
avoid pinching the Pulse Sensor Wires (71) or
the Upper Wire Harness (16).
7
6
Console
Wires
9
71
16
21
4
5
6. Attach the Seat (12) to the Seat Post (11) with four
Seat Screws (29) and four M8 Flat Washers (18).
Note: The Seat Screws and Flat Washers may be
pre-attached to the Seat.
Using an adjustable wrench, remove the Seat Knob
Assembly (31) from the Frame (1).
Insert the Seat Post (11) into the Frame (1). Slide
the Round Collar (13) down the Seat Post and
press it into the Frame. Secure the Round Collar to
the Frame with an M6 x 8mm Screw (26).
Reattach the Seat Knob Assembly (31) to the
Frame (1).
12
11
13
18
29
26
31
1
6
6
28
19
19
28
16
7
Hole
71