Filter
Top Products
7
3
3. Have another person hold the Console Base (52) near
the Uprights (117). Locate the wire harness extending
from the Console Base. Connect the wire harness to the
Wire Harness (55) in the Right Upright. The connectors
should slide together easily and snap into place.
If the
connectors do not slide easily and snap into place, turn one
connector and then insert it. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
Carefully feed the connectors and the excess wire har-
ness into the Right Upright (117). Then, carefully set the
Console Base (52) on the Uprights. Be careful not to
pinch the wire harnesses.
Tighten four Console Bolts (42) with Star Washers (113)
two to four turns into the Uprights (117) and the
Console Base (52).
After all four Console Bolts have
been started, tighten them.
113
113
42
42
117
52
55
Wire Harness
4. See the inset drawing. Identify the Right Top Handgrip
(53) (there are identifying marks inside of the Handgrips).
Set the Right Top Handgrip on the right Handgrip Post
(41). Insert two 1/2” Screws (51) into the two holes in
the Handgrip Post indicated by the arrows. Tighten
the Screws into the Right Top Handgrip.
Important: Be careful not to insert the two 1/2”
Screws (51) into the wrong holes in the Handgrip
Post (41), or tighten the Screws into the plastic
bosses on the bottom of the Right Top Handgrip (53).
Slide the front of the Right Top Handgrip (53) against the
Console Base (52). Then, firmly tighten the four 1/2” Tek
Screws (22) (only two are shown).
51
52
22
53
Left
41
Right
4
53
21
2. With the help of another person, carefully raise the
Uprights (117) to the vertical position, with the wheels and
the walking platform on the floor as shown on page 5.
Insert a Handgrip Post (41) into the tube on top of the left
Upright (117). If necessary, tap the Handgrip Post with a
rubber mallet to make sure that it is fully seated. Then,
tighten four 1/2” Tek Screws (22) several turns into the
tube and the Handgrip Post.
Do not fully tighten the Tek
Screws yet.
Attach the other Handgrip Post (41) to the right Upright
(not shown) as described above.
2
22
22
41
117
Bosses
55
Front