Razor MX500 Bicycle User Manual


 
q Chain and Tire Replacement
Tools required: Phillips screwdriver and two (2) 19mm wrenches.
1 Loosen screw and remove
chain guard.
2 Using two 19mm wrenches,
loosen both axle nuts.
3 Push the chain tensioner
down to loosen the chain
and remove the chain from the
wheel sprocket and
motor sprocket. Push and
remove the wheel downward.
Note: Your hands will get
greasy doing this.
4 Install the new chain or
wheel by slipping the chain
around the axle. Slide the axle
into the slots on the frame.
Slide the chain tensioner down
and maneuver the chain onto
the rear sprocket and front
sprocket.
5 Re-attach the chain guard.
Test ride and check. Readjust as
needed.
6
q Replacing the Fuse
REPAIR AND MAINTENANCE
WARNING:
To prevent shock, please follow
the instructions accordingly and
do not skip any steps.
1 Remove the seat fairing to lo-
cate the 3 fuse boxes attached
to the batteries.
2 Check all 3 fuses to see if
the fuse(s) have burnt out. If the
fuse(s) is(are) damaged, open
the fuse cover.
3 Remove any fuse that is
damaged or burnt out and
replace with a new one of equal
amperage.
Note: Amperage is located on
top of fuse.
3 Fuse boxes
Fuse checking cavity
Note: the arrangement of the
hardware sequence:
Right Side (Throttle)
Nut
Washer
Spacer
Left Side (Brake)
Nut
Washer
Spacer
Amperage
number