Filter
Top Products
4
q Attaching the Rear Caster Wheels
Required Tools: 5mm Allen wrench
1 Remove the four coupling
bolts from the frame using two
5mm Allen wrenches; one on top
and one on bottom.
2 Align the four holes in seat
with the four holes in frame. Insert
coupling bolts through the top and
bottom of the frame.
q Attaching the Seat
Required Tools: (2) 5mm Allen wrench
ASSEMBLY AND SET-UP
3 Tighten bolts using two 5mm
Allen wrenches; one on top and
one on bottom.
2 Using a 5mm Allen wrench,
tighten the hex bolt located on the
underside of the wheel cover until
the caster bolt is all the way inside
the frame.
Note: There should be no visible
threading between the frame and
the wheel cover (See Inset)
3 If you’re having trouble thread-
ing the caster into frame, use a rag
or small brush with a little WD-
40® to remove any excess particles
that may be caught in or around the
threading within the frame.
Need Help? Visit our web site for replacement parts and product support at www.razor.com, or call toll-free
at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
1 Insert the caster bolt into the
frame. If aligned correctly, the caster
thread should go half way into the
frame with no resistance.
Note: Make sure the spring washer
is on the caster bolt before inserting
the caster.