Filter
Top Products
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 21). To protect the floor or carpet, place a mat under the treadmill.
8. Attach a Wheel (66) to the inner side of the Base (69)
with a Wheel Bolt (64) and a Wheel Nut (109) as shown.
Do not overtighten the Wheel Nut. The Wheel should
be able to spin freely.
Attach a Wheel (66) to the other side of the Base (69) in
the same way.
69
64
66
109
8
9. Lower the Handrails (71, 72) to the floor. Align the Right
Handrail (72) with the indicated hole in the Base (69).
Finger tighten a 3 1/2” Bolt (61) with a 5/16” Washer (48)
into the Base and the Right Handrail. Attach the Left
Handrail (71) in the same way.
Make sure that the
Frame (86) is centered between the Handrails. Firmly
tighten the 3 1/2” Bolts (61) and the 2 1/2” Bolts (37).
See step 3. Firmly tighten the 1” Bolts (63). Then,
raise the Handrails (71, 72).
69
69
48
48
72
71
86
37
37
61
61
9
47
42
Opening
44
7. Insert the excess Wire Harness (42) into the large hole in
the side of the Right Handrail (72).
Securely tighten the
plastic ties on the bottom of the Console Base (47) to
prevent the Wire Harness from slipping. Then, cut off
the ends of the plastic ties.
Route the Wire Harness (42) through the indicated open-
ing in the Console Base (47). If you connected the Audio
Cable (56) in step 5, route it through the slot in the Wire
Cover (44). Attach the Wire Cover to the Console Base
with a 1/2” Silver Screw (49).
7
72
49
56
Ties
7