Filter
Top Products
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrench and your own phillips screwdriver and
adjustable wrench .
1. Identify the Right Upright (103), which has the Pulse
Wire (121) inside of it. Do not remove the rubber
bands from the Pulse Wire until the Pulse Wire has
been connected.
Have a second person hold the Console Base (64) near
the Right Upright (103) as shown. Feed the Wire
Harness (90) into the indicated hole near the upper end
of the right Upright and out of the hole near the lower
end of the Right Upright.
Connect the Wire Harness (90) to the Base Wire Harness
(126). If the connectors do not fit together easily, ro-
tate them and then connect them. Insert the connectors
into the Right Upright (103). Be careful not to damage
the Wire Harness during steps 1 through 5.
103
126
118
90
90
Hole
121
64
1
2. Have a second person hold the Right Upright (103) and
the Console Base (not shown) in a vertical position. Hold
the Right Upright against the Base (118) as shown.
Hand tighten two Upright Bolts (84) with Washers (125)
and Star Washers (89) into the Right Upright and the
Base; do not tighten the Upright Bolts yet. Be careful
not to pinch the Wire Harness (not shown) inside of
the Right Upright.
Attach the Left Upright (not shown) as described above.
Note: There are no wires in the Left Upright.
103
89
118
84
2
3. Hold the Pulse Bar (101) near the Right Upright (103).
Disconnect the ends of the Pulse Wire (121) in the Right
Upright from each other. Connect the wire in the Pulse
Bar to the Pulse Wire. If the connectors do not fit to-
gether easily, rotate them and then connect them.
Orient the Pulse Bar (101) so that the small screws in
the Pulse Bar are on the side shown by the arrow. Slide
the O-ring (129) onto the end of the Pulse Bar. Insert the
end of the Pulse Bar into the Right Upright (103). Hand
tighten a Pulse Bar Bolt (104) with a Washer (125) into
the Right Upright and the Pulse Bar. Do not tighten the
Pulse Bar Bolt yet.
Hand tighten the other Pulse Bar Bolt and Washer into
the Left Upright and the Pulse Bar (not shown). Note:
There is not a wire in the left end of the Pulse Bar.
104
125
101
121
129
103
6
3
125
Hole