Filter
Top Products
12
20. Attach a 2 3/4" Pulley (23) to the right Press Arm
(8) with an M10 x 53mm Button Bolt (61), two
M
10 Washers (71), two 5mm Spacers (25), two
Finger Guards (27), and an M10 Nylon Locknut
(73). See the inset drawing. Orient the Finger
Guards and Pulley as shown. Make sure the
Press Arm Cable (30) is in the groove of the
Pulley.
21. Make sure the Press Arm Cable (30) is routed
under the indicated welded rods.
Attach a “V”-pulley (22) to the Swivel Arm (16)
with an M10 x 64mm Button Bolt (75), two M10
Washers (71), two 5mm Spacers (25), and an
M10 Nylon Locknut (73).
20
21
7
3
3
0
71
71
61
8
75
71
16
71
73
25
25
30
22
25
27
23
2
7
25
Welded
Rods
2
7
27
25
22. Attach the Backrest (18) and the Backrest Base
(88) to the Upright (3) with the two M6 x 25mm
Screws (60) and the indicated M6 x 140mm
Screw (79).
22
79
60
60
18
3
88
23.
Attach the Headrest (90) and the Headrest Base
(89) to the Upright (3) with the two indicated M6 x
140mm Screw (79).
23
90
89
3
79