Filter
Top Products
9
10.Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may
be included. Keep the included allen wrenches in a secure place. The large allen wrench is used to adjust the
walking belt (see page 16). To protect the floor or carpet, place a mat under the treadmill.
7. See step 3. Firmly tighten the 1” Bolts (8).
Lower the Handrails (not shown) to the floor as shown.
Make sure that the Frame (75) is centered between
the Handrails.
Firmly tighten the 5/16” x 3” Bolts
(123).
Raise the Handrails to the vertical position.
75
123
123
7
8. Open part bag D. Attach the Storage Latch (14) to the
Left Upright (9) with two 3/4” Screws (13). Remove the
Latch Knob (106) from the Latch Pin (110). Make sure
that the Latch Pin Collar (108) and the Spring (107) are
on the Latch Pin as shown. Insert the Latch Pin into the
Storage Latch (14) and tighten the Latch Knob back onto
the Latch Pin.
110
108
107
14
106
9
13
1
8
9. Attach the Left Upper Body Arm (113) to the Left Upright
(9) with two 1/4” x 3” Bolts (102), two 1/4” Washers (39),
and two 1/4” Star Washers (111) as shown. See drawing
9a. Make sure that the Upper Body Arms (9, 114) are on
the indicated side of the Crossbar (34). Attach the Right
Upper Body Arm to the Right Upright (not shown) as de-
scribed above.
Firmly tighten all of the bolts and screws used in as
-
sembly steps 3 through 7.
113
111
114
9
34
111
39
9
102
9
9a