Filter
Top Products
7
2. Identify the Right Upright (62), which has a large round
hole near the lower end, and the Left Upright (9). See
inset drawing 2a.
Make sure that there are two U-Nuts
(124) in the lower end of each Upright.
Straighten the Wire Harness (21), and feed it into the
lower end of the Right Upright (62) and out of the upper
end. Next, slide the indicated slot in the Right Upright
onto the right Upright Lock Bracket (125) (see drawing
2b). Slide the Right Upright down until it reaches the Base
(11).
Make sure that the Wire Harness is not pinched.
Finger tighten two 5/16” x 3” Bolts (123) with two 5/16”
Star Washers (122) into the Base and the Right Upright.
With the help of a second person, tip the treadmill onto
its other side. Attach the Left Upright (9) as described
above. (Note: There is not a wire harness on the left
side.) Attach the other Wheel (not shown) to the Base
(11) as described in step 1.
9
62
125
11
Hole
2
21
Slot
123
3. With the help of a second person, raise the Right Upright
(62) and the Left Upright (not shown) to the vertical posi-
tion. Open part bag B. Identify the Right Handrail (47),
which has a large hole in the left side. Remove any plas-
tic ties from the rectangular bracket on the Right
Handrail. Feed the Wire Harness (21) up into the bracket
and out of the large hole in the left side. (Note: It may be
helpful to use needlenose pliers to pull the Wire Harness
out of the large hole.) Press a Handrail Cap (41) onto the
lower end of the Right Handrail as shown.
Insert the bracket on the Right Handrail (47) into the top
of the Right Upright (62) so the Handrail Cap (41) is rest-
ing against the Right Upright. Attach the Right Handrail
and the Handrail Cap with three 1” Bolts (8), three 1/4”
Washers (39), and two 1/4” Star Washers (111) as
shown.
Do not tighten the Bolts yet.
Attach the Left Handrail (not shown) as described above.
Note: There is not a wire harness on the left side.
4. Set the Crossbar (34) on the brackets on the Handrails
(1, 47). Attach the Crossbar with two Crossbar Screws
(53). Do not tighten the Crossbar Screws yet.
Open part bag C. Attach the end of the ground wire to
the small hole in the side of the Right Handrail (47) with a
Silver Ground Screw (104).
Bracket
41
47
62
111
111
21
Ground
Wire
47
104
53
1
53
34
3
4
39
39
39
8
8
8
Large
Hole
9, 62
124
122
11
Side
View
125
2b
2a