Filter
Top Products
6
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrenches and your own phillips screwdriver ,
rubber mallet , and adjustable wrench .
For help identifying the assembly hardware, see the drawings below. If a part is not in the parts bag, first
check to see if it has been pre-assembled.
If a part is missing, call toll-free 1-888-533-1333.
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully tip the
treadmill onto its left side as shown. Partially fold the
Frame (86) so the treadmill is more stable. Do not fully
fold the treadmill until it is completely assembled.
Insert an Extension Leg (63) into the base of the
Uprights (69) with the Base Pad (61) oriented as shown.
If necessary, tap on the Extension Leg with a rubber mal-
let. Next, hold two Extension Leg Nuts (46) in the bottom
of the Extension Leg, and insert two Extension Leg Bolts
(93) into the top of the Extension Leg. Firmly tighten the
Extension Leg Bolts into the Extension Leg Nuts.
Attach two Base Pads (57) to the base of the Uprights
(69) with two 1” Tek Screws (39).
3/4” Screw (2)–6
Wheel Nut (32)–2
Wheel Bolt (64)–2
Silver Ground
Screw (75)–1
1” Tek Screw (39)–4
Handrail Bolt (37)–4
Washer (38)–4
1/2” Screw (48)–6
3 1/2” Bolt (45)–4
Star Washer
(106)–4
Handrail Star
Washer (95)–4
Extension Leg
Nut (46)–4
Extension Leg Bolt (93)–4
5
63
86
61
57
69
39
39
93
46
1