Filter
Top Products
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires your own phillips screw-
driver and rubber mallet .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
For help identifying the assembly hardware, see the PART IDENTIFICATION CHART below.
2.
With the help of a second person, carefully lower the
treadmill frame and then tip the Uprights (69) down as
shown.
Make sure that the Extension Legs (102) remain
in the Uprights.
Attach each Extension Leg (102) with two 3/4” Screws
(100) as shown.
With the help of a second person, carefully tip the
Uprights (69) back to the vertical position.
Note: One replacement Base Pad (99) may be included.
Use the extra Base Pad if one becomes worn or needs to
be replaced.
1. With the help of a second person, carefully raise the
treadmill to the upright position as shown.
Insert one of the Extension Legs (102) into the treadmill
as shown. Make sure that the Extension Leg is turned
so the Base Pad (99) is on the bottom. If necessary, tip
the Uprights (69) forward as you insert the Extension
Leg.
Insert the other Extension Leg (not shown) in the same
way.
1/2” Screw (67)–4
3/4” Tek
Screw (100)–6
Latch Screw (74)–2
6
102
99
69
1
100
102
69
99
99
Frame
69
100
102
2