Filter
Top Products
2. Press the two Base Endcaps (99) (only one is shown)
into the Base (109). Make sure that the angle of each
Base Endcap matches the angle of the Base, as shown
in the inset drawing.
Attach two Base Pads (100) (only one is shown) to the
bottom of the Base (109) near the two Endcaps (99) with
four 3/4” Tek Screws (47). Note: There are no screw
holes in the Base Endcaps. Press firmly on the screw-
driver when tightening the Tek Screws.
With the help of a second person, carefully tip the tread-
mill so the four Base Pads (100) are resting on the floor.
2
109
100
21
47
4. Identify the left handrail, which has a hole in the indicated
location, and the right handrail. Hold the right handrail
near the Right Upright (82). Insert the Wire Harness (83)
into the large hole in the right handrail and out of the
upper end as shown.
Next, hold the right handrail against the Right Upright (82).
Tighten a 4” Bolt (112) three to four turns into the Right
Upright and the lower end of the right handrail. Tighten
two 5/16” x 1” Bolts (122) into the upper end of the right
handrail and the Right Upright.
Be careful not to drop
the Bolts into the handrail.
If necessary, raise or lower
the handrail to thread the 5/16” x 1” Bolts into the
Upright. Firmly tighten all three Bolts.
Attach the left handrail to the Left Upright (81)as de-
scribed above. Note: There is not a wire harness in the
Left Upright.
Press two Upright Endcaps (69) into the upper ends of
the Uprights (81, 82). Make sure that the notches in the
Upright Endcaps are up as shown.
4
82
81
83
Notch
Notch
69
69
122
122
Left
Handrail
Right
Handrail
Hole
112
112
99
109
3. Attach a Wheel (108) to each Wheel Housing (106) (only
one is shown) with a Wheel Bolt (107) and a Wheel Nut
(21).
Make sure that the Wheel Bolts are inserted
from the sides shown. Do not overtighten the Wheel
Bolts.
3
107
106
108
21
82
21
107
108
7
99