Filter
Top Products
7
5
1
2
33
Avoid pinching the
wires during this step
73
68
7
45
5. While another person holds the Upright (2) in
the position shown, connect the Extension Wire
(68) to the Lower Wire Harness (73).
Push the Extension Wire (68) and the Lower
Wire Harness (73) down into the Frame (1).
Slide the Upright (2) onto the Frame. Be care-
ful to avoid pinching the Wires. Attach the
Upright with two M10 x 74mm Button Bolts (7),
two M10 Split Washers (45), and two M10
Nylon Locknuts (33). Do not tighten the
Button Bolts yet.
6. Identify the Left Handlebar (6), which is marked
with a sticker. Insert the Left Handlebar into one
of the Handlebar Legs (5); make sure that the
Handlebar Leg is turned so the hexagonal
holes are on the indicated side. Attach the
Left Handlebar to the Handlebar Leg with two
M8 x 45mm Button Bolts (50) and two M8
Nylon Locknuts (38). Make sure that the
Nylon Locknuts are inside of the hexagonal
holes. Do not tighten the Button Bolts yet.
Insert the Pivot Axle (26) into the Upright (2),
and center the Pivot Axle. Apply a generous
amount of the included grease to both ends of
the Pivot Axle.
Turn a Handlebar Spacer (47) so that the small
arrow on the Handlebar Spacer is pointing
toward the floor, and slide the Handlebar
Spacer onto the post on the Left Handlebar (6).
Next, slide the Left Handlebar onto the Pivot
Axle (26).
Slide a Handlebar Washer (55) and a Wave
Washer (69) onto an M8 x 25mm Patch Screw
(56), and tighten the Patch Screw into the Pivot
Axle (26). Then, press the tabs on a Handlebar
Cap (46) into the Handlebar Spacer (47).
Assemble the Right Handlebar (8) and the other
Handlebar Leg (5) in the same way.
50
8
38
Grease
6
47
5
2
5
55
46
26
56
69
6
Hexagonal
Holes