ProForm PFTL99806.4 Treadmill User Manual


 
1
1
1. Make sure that the power cord is unplugged.
Remove the indicated 3/4" Screws (4) from the
Pulse Receiver Cover (70) on the back of the
Console Assembly (A).
2. Next, hold the receiver so the small cylinder
is oriented as shown.
Attach the receiver to
the Pulse Receiver Cover (70) with the two in-
cluded Small Screws (B).
3. Connect the Wire (C) on the receiver to the wire
extending from the Console Assembly (A).
Make sure that no wires are pinched.
Reattach the Pulse Receiver Cover (70) to the
Console Assembly with the two 3/4" Screws (4).
Discard the other wires included with the re-
ceiver.
If you purchase the optional chest pulse sensor (see page 20), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
A
1
70
4
A
3
70
Wire
Tab
4
C
70
Cylinder
2
B