Filter
Top Products
12
15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex
keys is used to adjust the walking belt (see pages 23 and 24).
54
Large
Barrel
13
7
51
7
55
14
13
14. Raise the Frame (51) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (55) so that the large
b
arrel and the Latch Knob (54) are in the posi-
tions shown.
Remove the tie from the upper end of the
Storage Latch (55). Attach the upper end of the
Storage Latch to the bracket on the Frame (51)
with a 3/8" x 2" Bolt (7) and a 3/8" Nut (13).
Attach the Latch Bracket (95) to the bracket on
the Base (90) with two 3/8" x 2" Bolts (7) and
two 3/8" Nuts (13). Note: It may be necessary to
move the Frame (51) back and forth to align the
Latch Bracket with the bracket on the Base.
Lower the Frame (51) (see HOW TO LOWER
THE TREADMILL FOR USE on page 21).
95
90
If you purchase the optional chest pulse sensor (see page 19), follow the steps below to install the re-
ceiver included with the chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated #8 x 3/4" Screw (1) and
the Access Door (104) from the Console Base
(98).
2. Connect the wire on the receiver to the indicated
wire extending from the Console Base (98). Hold
the receiver so the antenna is oriented as
shown and is facing the Console Base. Attach
the receiver to the plastic posts on the Access
Door (104) with the included small screws.
3. Be careful not to pinch the wires. Reattach the
Access Door (104) with the #8 x 3/4" Screw (1).
Discard the other wires included with the re-
ceiver.
Receiver
1
98
104
Antenna
Small Screws
Wires