Filter
Top Products
11
11. Be careful not to pinch the wires in the Right
Handrail (105).
Attach the console assembly to the Right
Handrail (105) with two #8 x 3/4" Screws (1), a
1/4" x 1 1/4" Bolt (6), and a 1/4" Star Washer
(10). Repeat this step on the left side of the
console assembly. Start all four Screws and
both Bolts before tightening any of them.
See steps 4–9. Tighten all the bolts used in
these assembly steps.
1
10
6
Console Assembly
105
11
10. Have a second person hold the console assem-
bly near the Right Upright (79). Connect the
Upright Wire (86) to the console wire. See the
i
nset drawing. The connectors should slide
together easily and snap into place. If they do
not, turn one connector and try again. IF THE
CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN YOU TURN ON THE POWER.
Then, remove the wire tie from the Upright Wire.
Insert the connectors and the excess wire into
the Right Handrail (105).
Set the console assembly on the Right Handrail
(105) and the Left Handrail (not shown). Be
careful not to pinch the wires.
79
Console
Assembly
10
86
Console
Wire
Console
Wire
Wire Tie
86
105