Filter
Top Products
21
THE INFORMATION MODE/DEMO MODE
The console features an information mode that keeps
track of the total number of hours that the treadmill has
been operated and the total number of miles or kilome-
ters that the walking belt has moved. The information
mode also allows you to switch the console from miles
per hour to kilometers per hour. In addition, the infor-
mation mode allows you to turn on and turn off the
demo mode.
To select the information mode, hold down the Stop
button while inserting the key into the console. When
the information mode is selected, the following informa-
tion will be shown:
The Distance display will
show the total number of
miles (or kilometers) that the
walking belt has moved.
The Time/Pace display will
show the total number of
hours the treadmill has been
used.
An “E” for English miles or
an “M” for metric kilometers
will appear in the Speed dis-
play. Press the Speed in-
crease button to change the
unit of measurement.
IMPORTANT: The Calories/Pulse display should be
blank. If a “d” appears in the display, the console is in
the “demo” mode. This mode is intended to be used
only when a treadmill is displayed in a store. When the
console is in the demo mode, the power cord can be
plugged in, the key can be removed from the console,
and the displays and indicators on the console will au-
tomatically light in a preset sequence, although the
buttons on the console will not operate. If a “d” appears
in the Calories/Pulse display when the information
mode is selected, press the Speed decrease button
so the display is blank.
To exit the information mode, remove the key.
THE OPTIONAL CHEST PULSE SENSOR
An optional chest pulse sensor provides hands-free
operation and allows you to use the console’s heart
rate programs. To purchase the optional chest
pulse sensor, call toll-free 1-800-734-2377.
If you purchase the optional chest pulse sensor, follow
the steps below to install the receiver included with the
chest pulse sensor.
1. Make sure that the power cord is unplugged.
Remove the indicated Screw (40) and the Access
Door (135).
2. Remove the paper from the adhesive pad on the
back of the receiver (A). Orient the receiver so the
small cylinder is near the lower edge of the re-
ceiver and is facing the Console Back (117) as
shown. Firmly press the receiver onto the indicated
corner of the Access Door (135). Connect the wire
on the receiver to the Pulse Wire (101) extending
from the Console Back.
3. Make sure that no wires are pinched. Reattach
the Access Door (135) with the Screw (40). Note:
The other wires included with the receiver may be
discarded.
A
117
135
Cylinder
40
101