Filter
Top Products
13
16. Make sure that there is a piece of cardboard
below the rear of the Frame (56).
See page 15 and plug in the power cord. Next,
s
ee page 17 and turn on the power. The incline
system will automatically calibrate and the
Frame (56) will move upward and downward.
I
f the incline system does not automatically cali-
brate, see step 4 on page 18 and press the
Incline increase button until the incline is at 0
percent.
When the Frame (56) stops moving, remove the
key from the console and unplug the power cord.
56
16
Cardboard
17. IMPORTANT: Before you begin this step,
make sure that you have calibrated the
incline system as described in step 16.
Raise the Frame (56) to the position shown.
Have a second person hold the Frame until
this step is completed.
Orient the Storage Latch (53) so that the large
barrel and the latch knob are oriented as shown.
Attach the upper end of the Storage Latch (53)
to the bracket on the Frame (56) with a 3/8" x
1 3/4" Bolt (6) and a 3/8" Nut (12).
Attach the lower end of the Storage Latch (53) to
the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8"
Nut (12). Note: It may be necessary to move the
Frame (56) back and forth to align the Storage
Latch with the Base.
17
53
12
Large
Barrel
56
6
Latch
Knob
12
3
94