Filter
Top Products
8
1. Make sure that the power cord is unplugged. Remove the
indicated 3/4” Screws (40) from the Console Back (117).
Remove the Console Back.
2. Connect the short jumper wire (A) to the wire on the re-
ceiver (B). Connect the other end of the short jumper wire to
the PULSE jack on the back of the Console (80).
Turn the receiver (B) so the cylinder is on the side
shown, and hold the receiver against the back of the
Console (80). Attach the receiver with the two small screws
(C) included with the receiver.
Make sure that no wires are pinched. See step 1.
Reattach the Console Back (117) with the 3/4” Screws (40).
You may discard the other wires included with the receiver.
If you purchase the optional chest pulse sensor (see page 22), follow the steps below to install the re-
ceiver and the short jumper wire included with the chest pulse sensor.
40
C
117
80
A
B
40
1
Cylinder
2