Filter
Top Products
5. Make sure that all parts are properly tightened before you use the treadmill. Place a mat beneath the
treadmill to protect the floor. For your benefit, familiarize yourself with the information on pages 25 and 26.
4. Raise the treadmill to the storage position (see HOW TO
FOLD THE TREADMILL FOR STORAGE on page 24).
Have a second person hold the treadmill in the upright posi-
tion. Position the U-base (20) against the base of the
Uprights (65) as shown, with the Bumpers (98) under the
U-base. Finger tighten two 2” Bolts (26) with Base
Washers (129) into the base of the Uprights and the U-
base. Then, attach the U-base with two 3” Bolts (23), two
Base Washers (129), and two Nuts (13). Tip the treadmill
forward if necessary. Tighten the two 2” Bolts.
7
55
69
5
70
3
72
68
62
10
Hole
3. Note: The parts shown in this step may be preassembled
but may need to be adjusted.
Raise the Frame (55) and have a second person hold it in
the position shown. Insert the Left Frame Guide (68) into
the left side of the Frame. Remove the Latch Knob (67)
from the Latch Pin (72). Make sure that the Latch Pin
Collar (70) and the Spring (69) are on the Latch Pin. Insert
the Latch Pin into the Frame and the Left Frame Guide.
Press the Latch Insert (5) onto the Frame, with the Latch
Pin in the center hole. Tighten the Latch Knob back onto
the Latch Pin.
Align the Latch Pin (72) with the hole in the Left Foam
Grip (62) by sliding the Left Frame Guide (68) up or down.
Make sure that the Latch Pin can be inserted fully into the
hole. Hold the Left Frame Guide in place and tighten two
1/2” Screws (10) into the Latch Insert (5) and the Left
Frame Guide. Note: It may be necessary to pull the Latch
Knob (67) to access and tighten the Screws.
67
13
23
20
98
98
65
4
13
26
129
23
26
129