Filter
Top Products
16
THE INFORMATION MODE/DEMO MODE
T
he console features an information mode that keeps
track of the total number of hours that the treadmill has
b
een operated and the total number of miles that the
walking belt has moved. The information mode also al-
lows you to select miles or kilometers as the unit of
measurement and to turn on and turn off the demo
mode.
To select the information mode, hold down the Stop
button while inserting the key into the console. When
the information mode is selected, the following informa-
tion will be shown in the display:
The center of the display will
show the total number of
miles (or kilometers) that the
walking belt has moved and
the total number of hours
that the treadmill has been
used. An “E” for English miles or an “M” for metric kilo-
meters will appear in the right side of the display. Press
the Speed increase button to change the unit of mea-
surement if desired.
IMPORTANT: If a “d” appears in the right side of the
display, the console is in the “demo” mode. This mode
is intended to be used only when a treadmill is dis-
played in a store. When the console is in the demo
mode, the power cord can be plugged in, the key can
be removed from the console, and the indicators in the
display will automatically appear in a preset sequence,
although the buttons on the console will not operate.
If a
“d” appears when the information mode is selected,
press the Speed decrease button so “d” disappears.
To exit the information mode, remove the key from the
console.
THE OPTIONAL CHEST PULSE SENSOR
A
n optional chest pulse sensor adds even more fea-
tures to the console. The chest pulse sensor offers
h
ands-free operation, and enables you to use the con-
sole’s two heart rate programs.
To purchase the op-
tional chest pulse sensor, call the toll-free tele-
phone number on the front cover of this manual.
If you purchase the optional chest pulse sensor,
follow the steps below to install the receiver in-
cluded with the chest pulse sensor.
1. Make sure that the key is removed from the con-
sole and that the power cord is unplugged.
Remove the indicated Screw (3) and the Access
Door (76) from the back of the Console Base (85).
2. Connect the wire on the receiver (A) to the indicated
wire extending from the Console Base (85). Hold
the receiver so the small cylinder is oriented as
shown and is facing the Console Back. Attach
the receiver to the plastic posts on the Access Door
(76) with the two included small screws.
3. Make sure that no wires are pinched. Reattach
the Access Door (76) with the Screw (3). Discard
the other wires included with the receiver.
Miles
Hours
A
85
Small
Cylinder
3
76
Wire
Small
Screws