Filter
Top Products
8. Make sure that all parts are properly tightened before you use the treadmill. Keep the included allen
wrench in a secure place; the allen wrench is used to adjust the walking belt (see page 21). To protect the
floor or carpet from damage, place a mat under the treadmill.
7. Remove the Lock Knob (92) from the Lock Pin (97).
Make sure that the Lock Pin Collar (95) and the Spring
(94) are on the Lock Pin. (Note: If there are two Lock Pin
Collars, place one on each side of the Spring.) Insert the
Lock Pin into the Storage Latch Housing (93) and tighten
the Lock Knob onto it.
95
95
97
93
94
92
15
7
5. Locate the ground wire extending from the Console
Base (64). Using the Silver Screw (124), attach the
metal ring on the end of the ground wire to the small
hole in the side of the Right Upright (103).
Connect the Pulse Wire (121) to the corresponding wire
extending from the Console Base (64). If the connec-
tors do not fit together easily, rotate them and then
connect them. Insert the excess wire into the Right
Upright (103).
64
121
Ground
Wire
6. While a second person holds the Console Base (64)
against the Right Upright (103) and the Left Upright (not
shown), tighten two 3/4” Screws (75) into each Upright.
Raise the Frame (not shown) to the vertical position so it
is center between the Right Upright (103) and Left
Upright (not shown). Refer to step 3. Firmly tighten the
four Upright Bolts (84). Refer to step 4. Rotate the Pulse
Bar (101) so the palms of your hands rest comfortably
on the metal pulse plates. Firmly tighten the two Pulse
Bar Bolts (104).
64
103
75
5
6
124
90
103
7
4. Hold the Pulse Bar (101) near the Right Upright (103).
Disconnect both ends of the Pulse Wire (121) in the
Right Upright from each other. Connect the wire in the
Pulse Bar to the Pulse Wire. If the connectors do not fit
together easily, rotate them and then connect them.
Orient the Pulse Bar (101) so that the metal pulse plates
on the Pulse Bar are on the side shown by the arrow.
Slide the O-ring (62) onto the end of the Pulse Bar.
Insert the end of the Pulse Bar into the Right Upright
(103). Hand tighten a Pulse Bar Bolt (104) with a
Washer (125) into the Right Upright and the Pulse Bar.
Do not tighten the Pulse Bar Bolt yet.
Hand tighten the other Pulse Bar Bolt and Washer into
the Left Upright and the Pulse Bar (not shown). Note:
There is not a wire in the left end of the Pulse Bar.
104
125
101
121
62
103
4