Filter
Top Products
8. Make sure that all parts are tightened before you use the treadmill. To protect the floor or carpet, place a
mat under the treadmill.
6
62
59
59
29
29
60
6
102
101
32
6. Refer to HOW TO FOLD THE TREADMILL FOR
STORAGE on page 11. Follow the instructions in step 2
to fold the treadmill.
Attach the lower end of the Right Handrail (62) to the
right Extension Leg (59) with a Screw (29). Attach the
lower end of the Left Handrail (60) in the same way.
Tighten all parts used in this steps 4, 5 and 6.
7. Remove the backing from the Adhesive Clip (101).
Press the Adhesive Clip onto the base of the right
Upright (32) as shown. Press the Allen Wrench (102)
into the Adhesive Clip.
7
4. Cut the plastic tie holding the cage nut in the upper end
of the Left Handrail (60).
Position the Left Handrail (60) against the left Upright
(32) as shown. The bracket on the Extension Leg (59)
should be inside of the lower end of the Left Handrail.
Thread a Handrail Bolt (30) with a Handrail Washer (31)
into the left Upright and the Left Handrail. Do not
tighten the Handrail Bolt yet.
While another person holds the Console Base (46), at-
tach the Right Handrail (62) in the same way. Be care-
ful to avoid damaging the wires in the Right
Handrail.
60
46
46
30
31
32
59
62
30
31
4
5. Make sure that the Console Base (46) is on the
Handrails (60, 62). Route the Console Wire Harness
(90) up into the Console Base as shown. Insert any
slack into the Right Handrail (62).
Attach the Console Base (46) to the Handrails (60, 62)
with four Screws (33).
90
62
60
46
33
33
5