Filter
Top Products
15
If the speed or incline settings are too high or too
low, you can manually override the settings at any
time by pressing the SPEED or INCLINE buttons
on the console. However, when the next ÒchirpÓ
is heard, the speed and/or incline will change
to the next settings of the CD or video program.
To stop the walking belt at any time, press the
STOP button on the console. The TIME display
will begin to flash. To restart the program, press
the START button or the SPEED
▲▲
button. After a
moment, the walking belt will begin to move at 1.0
mph. When the next ÒchirpÓ is heard, the
speed and incline will change to the next set-
tings of the CD or video program. The program
can also be stopped by pressing the stop button
on your CD player or VCR.
When the CD or video program is completed, the
walking belt will stop and the TIME display will
begin to flash. Note: To use another CD or video
program, press the STOP button or remove the
key and go to step 1 on page 14.
Note: If the speed or incline of the treadmill
does not change when a ÒchirpÓ is heard:
¥ make sure that the iFIT.com indicator is lit and
that the TIME display is not flashing. If the
TIME display is flashing, press the START
button or the SPEED
▲▲
button on the con-
sole.
¥ adjust the volume of your CD player or VCR. If
the volume is too high or too low, the console
may not detect the program signals.
¥ make sure that the audio cable is properly
connected, that it is fully plugged in, and that
it is not wrapped around a power cord.
¥ if you are using your portable CD player and
the CD skips, set the CD player on the floor or
another flat surface instead of on the console.
Follow your progress with the LED track and
the displays.
See step 5 on page 9.
Measure your heart rate, if desired.
Refer to step 6 on page 10.
When the program is completed, remove the
key.
See step 6 on page 11.
7
6
5