ProForm PFTL59120 Treadmill User Manual


 
7
7. Attach the matching Left Bottom Handgrip (82) with three
1/2” Screws (33).
Attach the Right Top Handgrip and the Right Bottom
Handgrip (not shown) as described above.
9
9. Remove the plastic ties from the Upper Body Arms (2). To
prevent damage to the Upper Body Arms if they are
moved too far sideways, the lower end of each Upper
Body Arm features a breakaway connector. If one of the
Upper Body Arms breaks away, simply press the
lower end back onto the Ball Joint (109, not shown).
Make sure that all parts are properly tightened before
you use the treadmill. Note: There may be hardware left
over after assembly is completed. Keep the included allen
wrench in a secure place; the allen wrench is used to ad-
just the walking belt (see page 26). To protect the floor or
carpet from damage, place a mat under the treadmill.
33
82
8
8. Carefully lower the Uprights (55, 64) as shown. Note: It
may be helpful to place your foot on one of the wheels
(58) as you lower the Uprights.
Press the Console Back (40) onto the back of the
Console Base (38). Make sure that Console Back and
Console Base are mated correctly and that no wires
are pinched. Tighten two 1/2” Silver Screws (114) into
the indicated holes. Tighten 3/4” Screws (37) into the
other holes in the Console Back.
Make sure that the left side of the Left Upright (64) is flush
with the left side of the Base (116). Firmly tighten, but do
not overtighten, the two Upright Bolts (112) in the left side
of the Base. Then, make sure that the Right Upright (55)
is flush with the right side of the Base. Tighten the two
Upright Bolts (not shown) in the right side of the Base.
Insert the Left and Right Cup Holders (39, 50) into the
large holes in the Console Base (38). If there is a small
hole under each Cup Holder, the two Small Clamps (110)
should be attached. Refer to the inset drawing. Loop a
Small Clamp through the hole in the bottom of a Cup
Holder and attach it with a 3/4” Screw (37). Attach a Small
Clamp to the other Cup Holder in the same way.
Raise the Uprights (55, 64) back to the vertical position.
40
39
50
38
37
114
114
112
64
55
116
58
2
2
109
37
110
8