Filter
Top Products
8
6. See drawing 6c. With the help of a second person, hold
the Console Base (101) near the Uprights (92, 95). Look
under the Console Base and locate the wires on the
sides of the Console Base. Make sure that the wires are
not routed through the openings for the Trays (109,
111). Drawing 6a shows the correct route for the wires.
Drawing 6b shows an incorrect route.
Locate the Wire Harness (74) in the Right Upright (95)
and the pulse wire in the Left Upright (92). Connect the
Wire Harness and the pulse wire to the connectors on
the sides of the Console Base (101). Make sure to con-
nect the connectors properly (see the inset draw-
ings). The connectors should slide together easily
and snap into place. If the connectors do not slide to-
gether easily and snap into place, turn one connector
and try again to insert it. IF THE CONNECTORS ARE
NOT CONNECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS TURNED ON.
Insert the excess Wire Harness and pulse wire up into
the Console Base.
101
95
92
6c
74
Pulse
Wire
6a 6b
Correct
Incorrect
74
5. Hold the pulse bar bottom against the Pulse Bar Top (71).
Make sure that the indicated box inside of the Pulse
B
ar Top is inserted into a cavity in the pulse bar bot-
tom.
Attach the pulse bar bottom with eight Screws (108).
T
ighten the Screws indicated by the arrows first, and
tighten the center Screws last. Be careful not to over-
tighten the Screws or to pinch any wires.
Next, identify the Right Top Endcap (75) and the Left Top
Endcap (81) by looking at the slots in the Top Endcaps.
Insert the Wire Harness (74) through the slot in the Right
Top Endcap, and press the Right Top Endcap into the
Right Upright (95). Insert the pulse wire through the slot
in the Left Top Endcap, and press the Left Top Endcap
into the Left Upright (92).
Make sure that the Top
Endcaps are oriented exactly as shown.
5
108
108
108
111
109
7. Set the Console Base (101) on the Left and Right
Uprights (92, 95). Thread the four Console Bolts (76)
with four Console Star Washers (77) into the Uprights
and the Console Base.
Be careful not to pinch the
wires (not shown) in the Uprights. Tighten the two
Console Bolts indicated by the arrows first; then, tighten
the remaining two Console Bolts.
Make sure that the Left and Right Trays (109, 111) are
pressed into the Console Base (101).
76
77
101
76
77
95
92
7
77
Box
Pulse Bar
Bottom
71
Pulse Wire
7
4
75
92
81
95
109
111