Filter
Top Products
17
4. Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
I
ncline increase and decrease buttons or one of
the numbered Quick Incline buttons. Each time you
p
ress the Incline increase or decrease button, the
incline will change by 0.5%. If you press one of the
numbered Quick Incline buttons, the treadmill will
adjust to the selected incline setting. Note: After
you press the buttons, it may take a moment for
the treadmill to reach the selected incline setting.
5. Follow your progress with the displays.
When the
manual
mode is se-
lected, the
upper half of
the display
will show a
track that represents 1/4 mile (400 m). As you walk
or run, indicators will appear in succession around
the track until the entire track appears. The track
will then disappear and the indicators will again
begin to appear in succession.
The upper half of the display can also show the
elapsed time, the distance you have walked or run,
the speed of the walking belt, the approximate
number of calories you have burned, your pace in
minutes per mile, and the incline of the treadmill.
Press the Display button repeatedly until the de-
sired workout information appears.
The lower left corner of
the display will show
the elapsed time, the
distance that you have
walked or run, and the
incline level of the
treadmill. Note: When a quick calorie burn workout
is selected, the display will show the time remain-
ing in the workout instead of the elapsed time.
The lower right corner of
the display will show the
approximate number of
calories you have
burned, the speed of the
walking belt, and your pace in minutes per mile.
The right side of the display will also show your
heart rate when you use the handgrip heart rate
m
onitor.
T
o reset the display, press the Stop button, remove
the key, and then reinsert the key.
6. Measure your heart rate if desired.
Before using the
handgrip heart
rate monitor, re-
move the sheets
of plastic from the
metal contacts. In
addition, make
sure that your
hands are clean.
To measure your heart rate, stand on the foot
rails and place your hands on the metal contacts—
avoid moving your hands. When your pulse is
detected, the heart symbol in the display will begin
to flash each time your heart beats, one or two
dashes will appear, and then your heart rate will be
shown. For the most accurate heart rate read-
ing, continue to hold the contacts for at least
15 seconds.
7. When you are finished exercising, remove the
key from the console.
Step onto the foot rails, press the Stop button, and
adjust the incline of the treadmill to the lowest
setting. The incline must be at the lowest set-
ting or you may damage the treadmill when you
fold it to the storage position. Next, remove the
key from the console and put it in a secure place.
When you are finished using the treadmill, press
the power switch into the off position and unplug
the power cord. IMPORTANT: If you do not do
this, the treadmillʼs electrical components may
wear prematurely.
Track
Metal Contacts