Filter
Top Products
9
7. Route the Upright Wire (28) through one of the
Handrails (18) as shown.
A
ttach the Handrail (18) to the Right Upright (36)
with two 5/16" x 2 1/4" Bolts (20) and two 5/16"
S
tar Washers (19). Be careful not to pinch the
Upright Wire (28).
Attach the other Handrail (18) to the Left Upright
(31) with two 5/16" x 2 1/4" Bolts (20) and two
5/16" Star Washers (19). Firmly tighten the four
5/16" x 2 1/4" Bolts.
31
28
20
19
18
2
0
19
18
7
28
18
9. While another person holds the Console Base
(26) near the right Handrail (18), attach the
ground wire on the Console Base to the right
Handrail with a #8 x 1/2" Ground Screw (27).
Connect the wire harness on the Console Base
(26) to the Upright Wire (28) as shown in the
inset drawing. If the connectors are oriented
correctly, they will slide together easily and
snap into place. If they do not, turn one con-
nector and try again. IF THE CONNECTOR IS
NOT INSERTED PROPERLY, THE CONSOLE
MAY BE DAMAGED WHEN THE POWER IS
TURNED ON.
27
26
Ground
Wire
28
Wire
Harness
9
36
8. Insert the included plastic tie (A) through the in-
dicated hole in the right Handrail (18). Make
sure that the Upright Wire (28) is secured to
the inside of the Handrail as shown. Then,
tighten the plastic tie.
Remove the wire tie from the Upright Wire (28).
8
A
28
18
Hole
Wire Tie
Wire
Harness