ProForm PFTL39509.0 Treadmill User Manual


 
11
13. Attach the Latch Housing (30) to the Left Upright
(31) with two #8 x 3/4" Screws (2). Make sure
that the large hole in the Latch Housing is on
the side shown. Do not overtighten the
Screws.
Locate the Latch Pin Assembly (29). Remove
the knob from the pin. Make sure that the collar
and the spring are on the pin as shown. Insert
the pin into the Latch Housing (30), and tighten
the knob back onto the pin.
2
30
31
Large
Hole
13
Knob
Pin
Collar
Spring
12. Attach the ground wire on the Upright Wire (28)
to the indicated hole in the Base (48) with a #8 x
1/2" Ground Screw (27).
Press the indicated Grommet (86) into the Right
U
pright (36).
Raise the Right Upright (36) and the Left Upright
(not shown).
48
2
8
36
12
27
Ground
Wire
86
Hole
14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex
keys is used to adjust the walking belt (see page 21).
29