Filter
Top Products
13
14. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear
plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-
mill. Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex
keys is used to adjust the walking belt (see pages 26 and 27).
13. Turn on the power (see page 16). See step 4
on page 17 and lower the incline to the low-
est position. Then, remove the key from the
console, switch the reset/off circuit breaker to
t
he “off” position, and unplug the power cord.
Raise the Frame (55) to the position shown.
Have a second person hold the Frame until
t
his step is completed.
Orient the Storage Latch (51) so that the
large barrel and the Latch Knob (52) are po-
sitioned as shown.
Attach the upper end of the Storage Latch (51)
to the Frame (55) with a 3/8" x 1 3/4" Patch Bolt
(6).
Attach the lower end of the Storage Latch (51) to
the Base (94) with a 3/8" x 2" Bolt (3) and a 3/8"
Nut (10). Note: It may be necessary to move the
Frame (55) back and forth to align the Storage
Latch with the Base.
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 24).
51
94
10
Large
Barrel
3
6
55
13
52