Filter
Top Products
13
15. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill.
Note: Extra hardware may be included. Keep the included hex keys in a secure place; one of the hex keys is
used to adjust the walking belt (see pages 27 and 28).
13. Turn on the power (see page 16). Next, adjust
the incline to the lowest position (see step 4 on
page 17). Then, remove the key from the con-
sole, press the power switch into the off po-
s
ition, and unplug the power cord.
Raise the Frame (55) to the position shown.
Have a second person hold the Frame until
s
tep 14 is completed.
Orient the Storage Latch (51) so that the large
barrel and the latch knob are in the positions
shown.
Remove the tie from the lower end of the
Storage Latch (51). Keep the holes in the latch
cap aligned with the holes in the Storage Latch.
Attach the Storage Latch to the Base (94) with a
3/8" x 2" Bolt (3) and a 3/8" Nut (10).
51
6
55
14
14. Remove the tie from the upper end of the
Storage Latch (51). Attach the upper end of the
Storage Latch to the Frame (55) with a 3/8" x
1 3/4" Screw (6).
Lower the Frame (55) (see HOW TO LOWER
THE TREADMILL FOR USE on page 25).
5
1
94
10
3
13
Latch
Cap
Latch
Knob
Large
Barrel
55