Filter
Top Products
4
ASSEMBLY
Assembly requires two persons. Place all parts of the recumbent cycle in a cleared area and remove the pack-
ing materials. Do not dispose of the packing materials until assembly is completed.
Assembly requires the included tools and your own adjustable wrench .
Use the drawings below to identify the small parts used in assembly. The number in parenthesis below each
drawing refers to the key number of the part, from the PART LIST on page 18. The second number refers to the
quantity needed for assembly. Note: Some small parts may have been pre-attached for shipping. If a part is
not in the parts bag, check to see if it has been pre-assembled.
M6 x 35mm Button
Bolt (70)–4
M6 Split
Washer (57)–4
M6 Nylon
Locknut (71)–4
M4 x 16mm
Screw (64)–2
M8 Flat Washer
(80)–4
M6 Flat
Washer (67)–4
M10 Split
Washer (46)–7
M6 x 16mm
Button Screw (68)–8
M6 x 12.7mm
Button Screw (62)–4
M10 x 25mm Button
Screw (81)–7
8
81
46
46
1. Attach the Rear Stabilizer (8) to the Frame (1) with
four M10 x 25mm Button Screws (81) and four M10
Split Washers (46).
1
1