Filter
Top Products
7
4. Orient the Crossbar (2) so the warning decal is
in the position shown. Attach the Crossbar to
the Right Upright (5) with two M8 x 92mm
Button Bolts (43), a Long Support Plate (29),
and two M8 Nylon Locknuts (34). Do not tight-
en the Nylon Locknuts yet.
Repeat this step with the Left Upright (4).
3. Identify the Left Upright (4), which has a “G580”
decal in the indicated location.
Press a Rear Base Foot (15) and a Front Base
F
oot (13) onto the Left Upright (4) as shown.
Remove the Upright Knob (21) from the Left
Upright (4). Rotate the Weight Rest (6) to the
position shown. Fully tighten the Upright Knob
into the Left Upright and the Weight Rest.
Attach a Locking Pin (26) to the Weight Rest (6)
with two M8 Plastic Washers (44) and an M8
Nylon Locknut (34).
Do not overtighten the
Nylon Locknut; the Locking Pin must pivot
easily.
Repeat this step with the Right Upright (not
shown). Make sure both Weight Rests (6) are
set to the same height.
21
3
4
2
43
43
29
34
5
4
4
6
26
44
44
13
15
Decal
3
4
Decal