Filter
Top Products
10
11. Apply a generous amount of grease to two Pedal
Leg Axles (32). Insert one Pedal Leg Axle into
the bottom of the Left Handlebar Leg (11). Insert
the other Pedal Leg Axle into the left Roller
Leg (21).
Apply a small amount of grease to both sides of
two Wave Washers (98). Place a Wave Washer
on each Pedal Leg Axle (32).
Orient the Left Pedal Leg (14) as shown, and
slide it onto the Pedal Leg Axles (32). Attach the
Left Pedal Leg to the Left Handlebar Leg (11)
with two M10 x 23mm Shoulder Screws (80), two
M10 x 20mm x 2mm Washers (92), and two Axle
Caps (31).
Attach the Left Pedal Leg (14) to the left Roller
Leg (21) with two M10 x 20mm Button Screws
(91) and two M10 x 25mm Washers (94); do not
overtighten the Button Screws. The Legs (11,
14, 21) must be able to pivot freely.
Repeat this step for the Right Pedal Leg (not
shown).
12. The Console (5) requires four 1.5V “D” batteries
(not included); alkaline batteries are
recommended. See the inset drawing. Remove
the battery cover from the Console and insert
four batteries into the Console. Make sure that
the batteries are oriented as shown by the dia-
gram in the battery compartment. Then, reattach
the battery cover.
Have a second person hold the Console (5) near
the Upright (6) as shown. Connect the console
wire to the Wire Harness (48). Insert the excess
wire downward into the Upright.
Attach the Console (5) to the Upright (6) with
four M4 x 16mm Self-tapping Screws (79).
13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
92
91
14
94
80
31
32
31
11
80
21
94
91
12
5
5
Battery Cover
Console
Wire
48
6
79
92
32
11
Grease
98
Grease
98