Filter
Top Products
50
8
38
7
6. Identify the Left Handlebar (6), which is marked with a
sticker. Insert the Left Handlebar into one of the
Handlebar Legs (5); make sure that the Handlebar
Leg is turned so the hexagonal holes are on the
indicated side. Attach the Left Handlebar to the
Handlebar Leg with two M8 x 45mm Button Bolts (50)
and two M8 Nylon Locknuts (38). Make sure that the
Nylon Locknuts are inside of the hexagonal holes.
Do not fully tighten the Button Bolts yet.
Insert the Pivot Axle (26) into the Upright (2), and cen-
ter the Pivot Axle. Apply a generous amount of the
included grease to both ends of the Pivot Axle.
T
urn a Handlebar Spacer (47) so that the small arrow on
the Handlebar Spacer is pointing toward the floor, and
slide the Handlebar Spacer onto the post on the Left
Handlebar (6). Next, slide the Left Handlebar onto the
Pivot Axle (26).
Slide a Handlebar Washer (55) and a Wave Washer (69)
onto an M8 x 25mm Patch Screw (56), and tighten the
Patch Screw into the Pivot Axle (26). Then, press the
tabs on a Handlebar Cap (46) into the Handlebar
Spacer (47).
Assemble the Right Handlebar (8) and the other
Handlebar Leg (5) in the same way
.
Grease
6
47
5
2
5
55
46
26
56
69
6
Hexagonal
Holes
5
1
2
33
Make sure the
wires and cables
do not get
p
inched and
damaged during
this step.
53
68
42
7
43
4
5
5. While another person holds the Upright (2) in the posi-
tion shown, connect the Extension Wire (68) to the
R
eed Switch Wire (53). Next, connect the Resistance
Cable (42) to the Lower Resistance Cable (43) in the
f
ollowing way:
•
See drawing A. Pull up on the metal bracket, and
insert the tip of the Resistance Cable (42) into the
wire clip on the Lower Resistance Cable (43) as
shown.
• See drawing B. Firmly pull the Resistance Cable
(42) and slide it into the metal bracket on the Lower
Resistance Cable (43) as shown.
• See drawing C. Using pliers, squeeze the prongs on
the upper end of the metal bracket together.
Push the excess cable and wires down into the Frame
(1). Slide the Upright (2) onto the Frame.
Do not
pinch the wires or cables. Attach the Upright to the
Frame with two M10 x 74mm Button Bolts (7), two M10
Split Washers (45), and two M10 Nylon Locknuts (33).
Do not tighten the Bolts yet.
43
43
Metal
Bracket
B
A
C
Control
Cable
Control
Cable