Filter
Top Products
7
6
57
5
2
6. Identify the Right Pedal (63), which has an “R” mold-
ed into its bottom surface, and the Right Pedal Tube
(
64), which is marked with a sticker.
Attach the Right Pedal (63) to the Right Pedal Tube
(64) with two M8 x 1 9/16” Hex Bolts (41), two M8
Washers (52), and two M8 Nylon Locknuts (57).
Attach the Left Pedal (not shown) to the Left Pedal
Tube (not shown) in the same way.
64
63
8
56
6
46
8. Insert a Plastic Sleeve (16) into the top of the right
Handlebar Leg (5). Then, insert a Handlebar (6) into
the right Handlebar Leg. Align the holes in the
Handlebar with the holes in the Handlebar Leg.
Attach the Handlebar with two M6 x 5/8” Pocket
Screws (46), two M6 Arc Washers (39), and two M6
Nylon Locknuts (56).
Attach the other Handlebar (6) to the left Handlebar
Leg (5) in the same way.
7. Apply a thin film of the included grease to the parts
shown at the right.
Slide a Wave Washer (50) onto the axle on the Right
Crank Arm (15). Next, slide the Right Pedal Tube (64)
onto the axle. Attach the Right Pedal Tube with an M8
x 3/4” Hex Bolt (26) and a Nylon Bushing (32).
Attach the Right Pedal Tube (64) to the right
Handlebar Leg (5) with an M8 x 2 1/2” Hex Bolt (40),
an M6 Washer (55), and an M6 Nylon Locknut (56).
Repeat this step to attach the Left Pedal Tube (not
shown) to the left side of the elliptical exerciser.
9. Make sure that all parts of the elliptical exerciser are properly tightened. Place a mat under the elliptical
exerciser to protect the floor or carpet from damage.
15
26
32
5
56
7
Grease
Grease
Grease
52
41
55
40
50
64
16
5
6
5
39
39
Grease