Filter
Top Products
7
10. Attach the Backrest (15) to the Seat Bracket (69)
with four M6 x 16mm Hex Head Screws (24).
11. Identify the Left Pedal (45) (there is an “L” on the
Left Pedal for identification). Using an adjustable
wrench, tighten the Left Pedal
counterclockwise into
the left arm of the Crank (29).
Tighten the Right Pedal (not shown) clockwise into
the right arm of the Crank (29).
Adjust the Left Pedal Strap (27) on the Left Pedal
(45) to the desired position. Press the Pedal Strap
onto the adjustment tab on the Left Pedal.
Adjust the Pedal Strap on the Right Pedal (not
shown) in the same manner.
15
24
69
29
27
45
Tab
10
11
9. Attach a Seat Handle (17) to the Seat Bracket (69)
with two M6 x 38mm Button Head Bolts (18) and
two M6 Nylon Locknuts (66).
Attach the other Seat Handle (17) to the Seat
Bracket (69) in the same manner.
69
17
18
66
17
9
12. The Console (8) requires either two or three “AA”
batteries (not included); alkaline batteries are
recommended. Open the battery cover (not shown)
on the back of the Console. Press the batteries into
the battery clip. Make sure that the negative (–)
ends of the batteries are touching the springs.
Close the battery cover. Note: If the battery clip
holds three batteries, you must insert three batteries.
8
Batteries
Battery
Clip
12
13. Make sure that all parts are properly tightened
before you use the recumbent bike. Note: There
may be some hardware left over after assembly is
completed.