Filter
Top Products
5
68
1
3
72
72
72
76
75
1
Wheels
74
1
1. Loosen the Lock Knob (68) on the right side of the
Frame (1). Slide the Seat Frame (3) out until it
stops. Tighten the Lock Knob.
Identify the Rear Stabilizer (76), which has no
wheels. Attach the Rear Stabilizer to the Seat Frame
(3) with two M10 x 58mm Carriage Bolts (74) and
two M10 Nylon Locknuts (72).
2. Identify the Front Stabilizer (75), which has wheels.
Attach the Front Stabilizer to the Frame (1) with two
M10 x 58mm Carriage Bolts (74) and two M10
Nylon Locknuts (72).
3. Attach the Upright (2) to the Frame (1) with three
M10 x 25mm Button Head Screws (25) and three
M10 Split Washers (26). Be careful not to pinch
the Reed Switch Wire (13) or the Resistance
Cable (10).
4. Route both Adapters (73) up through the Upright (2)
as shown.
Attach the Handlebar (4) to the Upright (2) with two
M6 x 25mm Hex Head Screws (14) and two M6 Split
Washers (67), but do not tighten the Screws yet.
Make sure that the Screws are threaded into the
indicated holes. Note: Two additional Screws will
be attached in step 6.
3
2
26
26
25
25
25
1
10
13
4
73
2
14
14
67
67
4
2
74