Filter
Top Products
9
8. Apply grease to the barrel of the M10 x 70mm
Bolt Set (54) and to the indicated locations on
t
he Leg Developer (8).
Attach the Leg Developer (8) to the Seat Frame
(6) with the M10 x 70mm Bolt Set (54). Make
s
ure the barrel of the Bolt Set is inserted
through both sides of the bracket on the
Seat Frame. Do not overtighten the Bolt Set;
the Leg Developer must pivot freely.
8
9
54
Grease
Grease
Grease
Bracket
8
6
54
9. Insert a Pad Tube (19) into the Leg Developer
(8). Slide a Foam Pad (20) onto each end of
the Pad Tube. Then, press a Pad Cap (46) into
each Foam Pad.
Repeat this step with the other two Pad
T
ubes (19).
10. Attach the Curl Bumper (24) to the Curl Frame
(9) with an M4 x 16mm Screw (47). Next, attach
the Curl Tube (23) to the Curl Frame (9) with an
M10 x 75mm Button Screw (55).
10
46
9
24
55
13
13
47
20
20
46
6
19
8
19
23
11. See the inset drawing and identify the Curl
Pin (25). Attach the Curl Frame (9) to the Leg
Developer (8) with the Curl Pin. Next, attach the
T
ether (58) to the Leg Developer with an M4 x
16mm Screw (47).
9
8
47
58
25
11
25
31