Filter
Top Products
6
ASSEMBLY
1.
Attach the Left and Right Bases (1, 2) with an
M10 x 16mm Bolt (51) and an M10 Nylon
Locknut (49). Do not tighten the Nylon
Locknut yet.
Next, attach the Center Base (3) to the Left and
Right Bases with eight M10 x 55mm Button
Bolts (53), eight M10 Washers (52), and eight
M10 Nylon Locknuts (49). Do not tighten the
Nylon Locknuts yet.
52
52
3
1
51
53
52
49
49
52
49
1
2
Before beginning assembly, make sure
that you have read and understand the
information in the box above. See the
PART IDENTIFICATION CHART on page 5
for help identifying small parts.
To hire an authorized service technician to
assemble the weight bench, call toll-free
1-800-445-2480.
Before beginning assembly, carefully read the
following information and instructions:
•
Because of its weight and size, the weight bench
should be assembled in the location where it will
be used. Make sure that there is enough clear-
ance to walk around the weight bench as you
assemble it.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until assembly is completed.
• T
ighten all parts as you assemble them, unless
instructed to do otherwise.
• As you assemble the weight bench, make sure all
parts are oriented as shown in the drawings.
• Assembly requires two persons.
• For help identifying small parts, use the PART
IDENTIFICATION CHART.
In addition to the included grease, assembly
may require the following tools (not included):
•
Two adjustable wrenches
•
One rubber mallet
• One standard screwdriver
• One Phillips screwdriver
Assembly may be more convenient if you have a
socket set, a set of open-end or closed-end
wrenches, or a set of ratchet wrenches.
Make Assembly Easier
Everything in this manual is designed to ensure
that the weight bench can be assembled suc-
cessfully by almost anyone. However, the weight
bench has many parts and the assembly
process will take time. By setting aside plenty of
time, assembly will go smoothly.
53
53