Filter
Top Products
Inspect and tighten all parts of the AIR WALKER reg-
ularly. Replace any worn parts immediately.
The AIR WALKER can be cleaned with a soft, damp
cloth. Keep liquids away from the electronic monitor.
Keep the monitor out of direct sunlight or the display
may be damaged. Remove the batteries when storing
the AIR WALKER.
REPLACING THE BATTERIES
If the display of the electronic monitor becomes dim,
or if the monitor does not function properly, the batter-
ies should be replaced. To replace the batteries, first
lift the monitor from the crossbar cover (see assembly
step 4 on page 5). Make sure that the reed switch
wire is fully connected to the wire on the monitor. To
replace the batteries, refer to assembly step 3 on
page 4.
HOW TO FOLD THE AIR WALKER FOR STORAGE
When the AIR WALKER is not in use, it can be folded
for storage. To fold the AIR WALKER, first remove the
lock knob from the left leg. Next, move to the front of
the AIR WALKER and place one foot on the round
tube. Firmly grasp the frame with your hands in the
locations indicated below. While holding the round
tube stationary with your foot, pull the top of the AIR
WALKER toward you until the uprights fold against
the frame. Place the AIR WALKER in a location
where it cannot fall.
8
STORAGE AND TROUBLE-SHOOTING
Frame
Round
Tube
Front
Hand
Back
Upright
Lock
Knob